Utilite & Trim-Slice Users Forum

Utilite installing software
Page 1 of 1

Author:  brentonb937 [ Wed Aug 26, 2015 8:00 pm ]
Post subject:  Utilite installing software

I am new to the Utilite and not a pro at Ubuntu so sorry if I got this wrong. I am running the Ubuntu 12.04 LTS 32bit (stock Utilite as far as I know) and am wanting to install some software to watch a camera system. the software is 32-bit but when it tries to install it says "wrong Architecture 'i386'". Any help is appreciated, thank you in advance.

Author:  duri [ Sat Aug 29, 2015 5:45 pm ]
Post subject:  Re: Utilite installing software

Sounds like that software is not for the ARM Architecture

Author:  brentonb937 [ Mon Aug 31, 2015 2:48 pm ]
Post subject:  Re: Utilite installing software

is there a way around that?

Author:  2kanaa [ Mon Aug 31, 2015 8:58 pm ]
Post subject:  Re: Utilite installing software


http://forum.eltechs.com/viewtopic.php? ... 682449c870

Author:  hassellbear [ Mon Aug 31, 2015 11:43 pm ]
Post subject:  Re: Utilite installing software

As duri has indicated, it seems the software binary you are attempting to install is compiled for i.386 architecture. Utilite uses ARM architecture and will not run an i.386 binary. You may consider trying the following.

1. Try to locate suitable software which has a pre-compiled binary for ARM systems. Based on the OS you are using, such a binary must be for Armel and not for Armhf.

2. If your selected software is open source and an ARM binary is not available, then you may be able to compile from source code. It's not as bad as it sounds. If you find something you like, the community will certainly lend a hand to help.

3. If 1 and 2 above are not options. you can try the i386 emulator listed above. The only concern with the emulator approach is there may be a performance penalty. In 2014 Compulab tested the Eltech Exagear i386 Emulator on Utilite, and those tests revealed some performance shortcomings. However, if a free trial period is available, it's certainly worth a shot.

4. If your camera application is security related, you may be able to use the Open Source package called Zoneminder. i ran a test application on Utilite, and Zoneminder worked just fine. See:


Best regards and good luck,

Darryl Hassell

Author:  paodopless [ Mon Mar 25, 2019 2:26 pm ]
Post subject:  Re: Utilite installing software

This is a very helpful blog. Thank you

Best Drip Coffee Maker

Author:  Natashcken [ Sat Apr 20, 2019 11:01 am ]
Post subject:  Re: Utilite installing software

Installing of the software need to come and then for the utilize series are compiling from the figure of the out and software is only for the camera. Wrong part of the architectures need to be really professional of best essay writing services uk and coming time this installation will system to running.

Author:  paodopless [ Fri Apr 26, 2019 3:00 pm ]
Post subject:  Re: Utilite installing software

Nice post, thanks for sharing with us.
keep sharing more such kind of interesting articles. Thanks again.

pakistan Railway Information

Author:  clarkblogger01 [ Sun May 12, 2019 9:15 pm ]
Post subject:  Re: Utilite installing software

More at idm serial key

Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group